Dirk Broer
03-22-2016, 11:45 PM
I know it is possible to run QCN or its related projects on a Raspberry Pi, but the help you get from their forum leaves much to be desired.
"This Project doesn't support computers of type arm-unknown-linux-gnueabihf (http://qcn.stanford.edu/sensor/forum_thread.php?id=975)"
In the most lucky event you get pointed to a -no longer existing- special boinc client from their own -former- website.
Is there anyone here that runs QCN on a Pi? I want to run QCN, using the Raspberry Sense Hat (https://www.raspberrypi.org/products/sense-hat/).
So far I discovered that any ARM-based computer from our team that runs these projects does that through Android, a no-go for the Pi (officially).
Edit: I managed to download the 'special ARMv6 client (https://www.raspberrypi.org/forums/viewtopic.php?f=63&t=667&start=75)' 7.1.0 or so. To be continued...
"This Project doesn't support computers of type arm-unknown-linux-gnueabihf (http://qcn.stanford.edu/sensor/forum_thread.php?id=975)"
In the most lucky event you get pointed to a -no longer existing- special boinc client from their own -former- website.
Is there anyone here that runs QCN on a Pi? I want to run QCN, using the Raspberry Sense Hat (https://www.raspberrypi.org/products/sense-hat/).
So far I discovered that any ARM-based computer from our team that runs these projects does that through Android, a no-go for the Pi (officially).
Edit: I managed to download the 'special ARMv6 client (https://www.raspberrypi.org/forums/viewtopic.php?f=63&t=667&start=75)' 7.1.0 or so. To be continued...