BC
08-05-2004, 12:29 PM
Ok guys....
I had this puppy tweaked and lost it.... can't find my notes either.
SK8N motherboard.... Corsair CL2, registered ECC (shows as 3-3-3-8)
runs dual channel. DDR-400 ram... but I calculate only 153 mhz effective
mem read is 2.4GB/sec.... write is only 1.6G.... Yes, pathetic.
but this is 32 bit XP mode too.
I need to remember or be told the master ecc on/off,
dram ecc on/off, flush settings, I remember something about 84 ms
for repair etc,,... just not enough to get my write speed back up to 1.7-1.8
cas, trp, trd,, etc, etc..... I TOTALLY lost the info
Sorry... I gotta get this back... Memory peformance SUCKS
CPU/FPU and everything else is right on the money... just memory is
out the window..... and embarassing. Even graphics are on spec.
BIOS is even calling it 200 Mhz clock..... which is even worse....
I had it right once... it CAN be done again....
Who know's the magic??
Thanks in advance
BC
I had this puppy tweaked and lost it.... can't find my notes either.
SK8N motherboard.... Corsair CL2, registered ECC (shows as 3-3-3-8)
runs dual channel. DDR-400 ram... but I calculate only 153 mhz effective
mem read is 2.4GB/sec.... write is only 1.6G.... Yes, pathetic.
but this is 32 bit XP mode too.
I need to remember or be told the master ecc on/off,
dram ecc on/off, flush settings, I remember something about 84 ms
for repair etc,,... just not enough to get my write speed back up to 1.7-1.8
cas, trp, trd,, etc, etc..... I TOTALLY lost the info
Sorry... I gotta get this back... Memory peformance SUCKS
CPU/FPU and everything else is right on the money... just memory is
out the window..... and embarassing. Even graphics are on spec.
BIOS is even calling it 200 Mhz clock..... which is even worse....
I had it right once... it CAN be done again....
Who know's the magic??
Thanks in advance
BC